Author Topic: vx800 big bore restoration...  (Read 1535 times)

Offline superturbocompound

  • Sr. Member
  • ****
  • Posts: 160
    • http://
vx800 big bore restoration...
« on: January 03, 2020, 02:51:08 AM »
hi all, early part of my vx800 (vx950) restoration, some lousy engineering done by the local machine shop, need to do it again, and order a set of bearings for the crank.

Opps , some contact between the valve and piston, hope i didn't bend the valves.didn't run the engine long though , just a few minutes. i did change the gasket to a 1mm from the my fault for not checking the piston to valve clearence

just checking the contact surface of the rings and the piston ring land, upper rings are good but the lower compresson rings  not 100%...
ebay i.d. ariasher230802