Author Topic: vx800 big bore restoration...  (Read 572 times)

Offline superturbocompound

  • Sr. Member
  • ****
  • Posts: 160
    • http://
vx800 big bore restoration...
« on: January 03, 2020, 02:51:08 AM »
hi all, early part of my vx800 (vx950) restoration, some lousy engineering done by the local machine shop, need to do it again, and order a set of bearings for the crank.
https://youtu.be/WSvpvEWTdw0

Opps , some contact between the valve and piston, hope i didn't bend the valves.didn't run the engine long though , just a few minutes. i did change the gasket to a 1mm from the 2mm...so my fault for not checking the piston to valve clearence
https://ibb.co/gmvCxV0

just checking the contact surface of the rings and the piston ring land, upper rings are good but the lower compresson rings  not 100%...
https://ibb.co/XYnJVNR
https://ibb.co/zJFBLds
https://ibb.co/WPPgt3d
https://ibb.co/dLCTfBT
ebay i.d. ariasher230802

 

anything